Magnet Enameled Copper 0 0418 Diameter

Magnet Enameled Copper 0 0418 Diameter

MAGNET WIRE SOLID COPPER SPN, NEMA-MW-80 155C This magnet wire is copper core with a dual film of polyurethane (85-90 percent) with polyamide(nylon) as an outer coating comprising the other 10-15 percent. Magnet wire is insulated for the winding of electromagnets and for coils for transformers and other electrical applications

Magnet Enameled Copper 0 0418 Diameter Picture

Magnet Enameled Copper 0 0418 Diameter Photo

Magnet Enameled Copper 0 0418 Diameter Pic

Magnet Enameled Copper 0 0418 Diameter Picture

Most helpful client reviews

8 of 8 people found the following review helpful.
This SUX
By NumbNut
Ok, after reading all the other reviews, I expected this to be wound poorly. Unfortunately, I found that you can’t get more than a couple hundred feet of usable wire from this CRAP even if you undertake to unwind it carefully. Count on 50% waste wire untangling messes from the spool. If it WERE wound by hand, I’d suppose better. It seems they just spun a spool until a pound of scrap metal is wound on it, and ship it to you. If they just put the tangled mess in a cardboard box without the spool, you might have better luck. I don’t understand how you may screw up winding wire on a spool this badly!

6 of 6 persons found the following review helpful.
Wire has clear lacquer, hard to see
By gerakis
The insulative lacquer is clear, and darn near invisible. Its not red, like in the picture, so it is difficult to tell incisively where on the wire I have got rid of insulation.

Both open flame and sandpaper appear to be very effective at lacquer removal.

However, the spool appears to be the suitable size and length, it conducts well, and is in truth magnet wire. Seems like a decent product for a nice low price.

7 of 8 humans found the following review helpful.
Poorly wound on the spool
By Andrew K. Galloway
The wire looks like it was wound by hand. I am employed to better which I have always been competent to buy elsewhere, even Radio Shack gets it right.

The problem is when you are laying down your turns, you cannot get the turns uniform and 100% coverage and there are gaps among the turns. I won’t buy again from this mfg.

Might be okay for a lot of kind of craft work where you cannot see the wire when you are done.

See all 14 client reviews…